	# max pin width (perpendicular to axis of package) (1/100 mil)
	# max pin length (parallel to axis of package) (1/100 mil)
	# gap between the pads (1/100 mil)
	# package width (1/100 mil)
	# package height (1/100 mil)
	# component veritcal height off board (1/100 mil)
	# pad width and length
	# y values for drawing the pad.  The Y center of the pad is 0.5*(PINL + PINS)
	# we need a line segment of length PADL - PADW so we have end points:
	# 0.5*(PINL + PINS) +/- 0.5*(PADL - PADW)
	# width of soldermask relief (5 mil on each side)
	# silkscreen width (1/100 mils)
	# how much space to leave around the part before the
	# silk screen (1/100 mils)
	# lower left corner for silk screen (1/100 mil)
	# upper right corner for silk screen (1/100 mil)
	# how much to notch the corners by in silk to indicate polarity
# Element [SFlags "Desc" "Name" "Value" MX MY TX TY TDir TScale TSFlags]
Element[ "" "Description_nichicon_NICHICON_WT_CAP_6p3_5p4" "" "`NICHICON_WT_CAP_6p3_5p4'" 0 0 0 0 0 100 ""]
(
# Pad [rX1 rY1 rX2 rY2 Thickness Clearance Mask "Name" "Number" SFlags]                                                                                              
Pad[ 0 -12992 0 -5905 5149 1000 6149 "Plus"  "1" "square"]
Pad[ 0  12992 0  5905 5149 1000 6149 "Minus" "2" "square"]
# Silk screen around package
# ElementLine[ x1 y1 x2 y2 width]
ElementLine[ 14685    14685     3874    14685    1000]
ElementLine[ 14685    14685     14685    -11685 1000]
ElementLine[ 14685    -11685  11685 -14685    1000]
ElementLine[ 11685 -14685     3874    -14685    1000]
ElementLine[ -14685    14685    -3874    14685    1000]
ElementLine[ -14685    14685    -14685    -11685 1000]
ElementLine[ -14685    -11685 -11685 -14685    1000]
ElementLine[ -11685 -14685    -3874    -14685    1000]
)
